PVC 205

Thank you for your question. We can offer the following advice:

"If it is an acute 90º bend then there is too much material to shrink back or stretch.

Some of the builders get round this by heating the corners up and pulling it around the corner under force.

Given that this is a retail customer we can suggest heating and stretching it around although they may not be able to exert the same pressure, in this instance it may be necessary to remove a small triangle of material on both the top and bottom at the apex of the radius."

We hope that this assists but please do not hesitate to contact our office should you require naything further.

Kind regards,

The Wilks Team